Connect with us

Renewable Energy Times

Korean scientists hit 12% efficiency on non-fullerene organic cell

Solar

Korean scientists hit 12% efficiency on non-fullerene organic cell



A research team from South Korea’s Ulsan National Institute of Science and Technology has demonstrated a new process for the creation of organic solar cells. Using this method, the team has created cells with a conversion efficiency up to 12.01%.

Researchers at the Ulsan Institute of Science and Technology (UNIST) have reached 12.01% efficiency on an organic solar cell, using a process which they say solves many of the complexities that have kept organic PV from large-scale production, in particular an issue of efficiency loss, where the active cell layer is much thicker than 100 nanometers.

The process, described in the paper Ultrafast Channel II process induced by a 3-D texture with enhanced acceptor order ranges for high-performance non-fullerene polymer solar cells, published in the journal Energy & Environmental Science, utilizes a non fullerene acceptor, and demonstrated efficiencies close to 10% when the active layer thickness was increased to 300nm.

“Photoactive layers in the existing OSCs are rather thin (100 nm), and therefore it has been impossible to handle them via large-area printing process,” explains Changduk Yang, Profesor at UNIST’s School of Energy and Chemical Engineering. “The new photoactive layer maintained its initial efficiency, even when the maximum measured thickness being in the range of 300 nm.”

This breakthrough, according to UNIST, could allow for the development of large-area printing processes, which could lead to production costs low enough to compensate for the conversion efficiencies achieved with other technologies.

“This study highlights the importance of optimizing the trade-off between charge separation/transport and domain size to achieve high-performance NF-PSCs,” says Professor Yang. “Our study presents a new pathway for the synthesis of non-fullerene photoactive materials, we hope to further contribute to the production and commercialization of high-efficient OSCs cell.”

Earlier in 2018, scientists at New York University’s Tandon School of Engineering used a crystallizing agent to pass 10% efficiency on a non-fullerene organic cell, while another U.S. research team managed to stack two different organic solar cells on top of each other, achieving 15% efficiency in the process.



Source PV Magazine

Click to comment

Leave a Reply

Your email address will not be published. Required fields are marked *

More in Solar

Categories

September 2018
M T W T F S S
« Aug    
 12
3456789
10111213141516
17181920212223
24252627282930

Follow

Subscribe to notifications
To Top
%d bloggers like this: